Motion Raceworks – RIFE Sensor Blocks: Simplify and Perfect EFI WIRING

RIFE Sensors (TBM Brakes) recently released these unique and ground breaking sensor blocks, which simplify wiring, give you a higher quality sensor, seal things from the elements and reduce vibration concerns. Best of ALL, they cost less than the four sensors bought separately as used by traditional EFI systems.

These sensors can be used in conjunction with Holley EFI, Megasquirt, Fueltech, Haltech, AEM and more. So long as you can scale the 5v sensor in your aftermarket EFI system, these work for you.

The interchangable “slugs” as we will refer to them as allow you to replace a sensor, swap for a different sensor, or move things around in minutes. Meaning no rewire, no adaptor plugs when going from one style map sensor to another, no re plumbing. The best part is going from a 3 bar map to a 5 bar map is as simple as a quick slug change, then open your EFI system program, change the sensor scaling and move about your day.

The outer billet case is sealed with a rubber seal from the bottom. Additionally each slug has the internal sensor “potted” in silicone to reduce vibration effects and life on the sensor, additionally the sensors sit in an oring seat so that no solid case contact is made. This creates the ultimate “remote mount” sensor block.

These blocks are available in 3AN male and 1/8″ NPT female. Additionally they’re available as single, dual, triple, and quad sensor blocks.

To order the Motion Boost Ready Quad block click below. This comes with (1) 4 bar map, and (3) 100 psi transducers.

https://www.motionraceworks.com/produ…

For a custom config Quad Block: Make sure to enter configuration of sensors in notes at checkout. https://www.motionraceworks.com/produ…

Triple Block: https://www.motionraceworks.com/produ…

Dual Block: https://www.motionraceworks.com/produ…